EHEIM aquastar 63 marine Manual De Instrucciones página 15

English
‧ Only carry out the work described in these instructions.
‧ Only use original spare parts and accessories for the appliance.
‧ The appliance must be protected by a residual current protection device
with a maximum rated residual current of 30 mA. Please contact an
electrician if there are any questions or problems.
‧ In the event of leakage or when the residual current protection device is
triggered, immediately disconnect all devices in the aquarium from the
power supply.
‧ If they are not being used, always disconnect all devices in the aquar-
ium from the power supply before you install/remove any parts and
before all cleaning and maintenance work.
‧ Heed the operating manuals for the micro interior filter, flow pump,
nano skimmer and air pump, especially the chapters on safety, com-
missioning, operation and maintenance.
‧ Protect the mains socket and mains plug against moisture. It is recom-
mended to form a drip loop with the mains cable to prevent any water
running along the cable to the mains socket.
‧ The electrical data of the LED light must match the data of the power
mains. This data is found on the type plate, the packaging and in these
instructions.
‧ The distance from the underside of the light to the highest water mark
must be a minimum of 15 mm.
4. Preparation
Unpacking
‧ Carefully remove all components from the packaging and make sure that nothing is missing or damaged.
Accessories
The scope of delivery contains the following accessories:
‧ Micro interior filter (Mini Up) (2204020)
‧ StreamON flow pump (1070220)
‧ skim marine 100 nano skimmer (3551000)
‧ Air pump AIR 100 (3701010)
15