Pre Operational Checks; Transport - Husqvarna Soff-Cut 150 Manual De Instrucciones

ASSEMBLING AND ADJUSTMENTS
• Mount the outer blade flange. Tighten the bolt firmly.
• Install a new skid plate.
Hook the front of the skid plate on the front blade block
shaft pin.
Connect the rear blade block shaft and the rear of the skid
plate by installing the locking pin.
• Mount the blade block guard. Tighten until fully seated
against the blade block.
• Lift the front and rear of the skid plate to ensure the blade
slides freely through the skid plate.
• Ensure the lexan cover move freely up and down.

Pre operational checks

The engine is delivered without oil. Fill with engine oil to the
correct level. Refer to Technical Data for recommendations on
which oil type to use.

Transport

• Remove the locking pin.
• Fold the handle forward.
• Fold the guide arm back.
• The saw should be lifted from the center handle on the roll
cage.
10 –
English