Assembling And Adjustments; General; Unpacking; Fit The Blade - Husqvarna Soff-Cut 150 Manual De Instrucciones

ASSEMBLING AND ADJUSTMENTS

General

WARNING! The engine should be switched
!
off during operations described in this
chapter unless otherwise stated. Remove
the ignition cable from the spark plug to
prevent accidental engine starting.

Unpacking

• Remove the saw from the package. Use proper lifting
technique. The saw should be lifted from the center
handle on the roll cage.
• Discard or recycle the packing material per your regional
laws.
No diamond cutting blade or skid is included with the saw.
Purchase the appropriate blade and skid plate from your local
Husqvarna Construction Product dealer.

Fit the blade

CAUTION! Inspect the blade for damage,
!
cracks, loss of segments, warping,
overheating, excessive wear or a damaged
tri-arbor hole. If the blade shows any of
these problems, discard the blade.
Make sure the blade is marked with a
maximum operating speed greater than 4450
rpm.
Inspect blade flanges for damage, excessive
wear and cleanliness. The blade should fit
snugly on clean, undamaged, tri-arbor shaft.
• Fold the handle to its full upright position.
• Insert the locking pin.
• Raise the blade by pushing down on the handle bar with
both hands to the full and locked position.
• Remove the blade block guard.
• Insert one the two wrenches supplied, in the slot at the
front of the engine and one on the blade shaft bolt.
• Rotate the blade shaft counter-clockwise with wrench on
the blade shaft bolt until the second wrench engages the
flats on the other end of the shaft.
• Remove the blade shaft bolt by continuing to turn the bolt
counter-clockwise.
• Remove the outer blade flange.
• Discard the old skid plate.
NOTICE! The patented skid plate is the most important part
of the Soff-Cut Ultra Early Entry system. If it is bent, twisted
or damaged, spalling and raveling of a cut may result. Store
skid plates carefully and install them properly. Install a new
skid plate with each new blade. Never re-use skid plates.
• Thoroughly clean the concrete from the shaft, blade block
and blade block guard.
• Mount the clean blade on the blade shaft.
– 9
English