Change; Air Cleaner Element; Additional Engine Information - Husqvarna Soff-Cut 150 Manual De Instrucciones

Change

Oil
Change oil after the first 20 hours of use thereafter every 100
hours.
Change the engine oil while the engine is hot.
• Turn off the engine.
• Place a pan under the drain and remove the plug.
• Let the oil run out into the container.
• Put the plug back and fill with new oil.
• When full, the oil level should be at the high level mark on
the dipstick.
Oil sensor
The engine is equipped with an oil alert system that will stop
the engine if the oil level is low.
The engine cannot be started unless the level is raised above
the prescribed limit.
Disposal
Used engine oil is a health hazard and must not be disposed
of on the ground or in nature; it should always be disposed of
at a workshop or appropriate disposal location.

Air cleaner element

See cleaning instructions under the heading "Cleaning".
• Replace the paper element monthly or earlier if
necessary.

Additional engine information

Please see the engine Operator's Manual for additional
information about servicing the engine.
The manual also has specific information about
specifications, tune-up parts, engine warranty, emission
compliance, etc.
18 –
English
MAINTENANCE