babymoov A014403 Manual De Instrucciones página 11

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 21
/ Transmitter
• Plug the transmitter on the mains.
• Set the power ON/OFF switch (19) to ON position to turn on the unit. The power on indicator (13) will light
up green.
• To limit the emission of electromagnetic waves in the area around the baby, we advise you to use the
VOX (voice activation) function : communication between the emitter and the receiver will only be triggered
when the microphone detects a noise. This will prevent continuous operation of the 2 units. To select the
voice activation function, switch the button (20) to " uto".
• Place the transmitter at least 1 m from the cradle, directing the camera (14) and the microphone (12) towards
the baby.
• The night light (16) can be set permanently ON by moving the switch (18) to position on. The night light
can also be set to be VOX (voice activated) by moving the switch (18) to position uto. Under VOX mode,
the night light will be switched on once the microphone detects a sound and automatically goes off a
few seconds after the microphone stops picking up any sound.
• The baby unit is equipped with automatic night vision function. Whenever the light sensor detects a low
light intensity in baby's room, it will automatically switch on the IR (Infrared) LEDs (15) as a source of
illumination. The camera captures the IR images of the baby and transmits to the parent unit which is
displayed as a black/white image on screen.
B / Receiver
• Set the power switch (6) to ON position to turn on the unit.
• Place the receiver at a reasonable distance away from the transmitter to avoid feedback. Too close a distance
will create a screeching sound.
• Once the unit receives a signal from the transmitter, the images captured by the camera should be
shown on the screen, while the sound picked up by microphone should be heard from speaker.
• The loudspeaker volume can be adjusted by using buttons +/- (1).
• The screen brightness can be adjusted by using buttons +/- (2).
• When several cameras are being used at once, you can select the camera to be displayed using the switch
(8) Place this switch in the " uto" position if you want the various cameras to be displayed in succession.
• To save the battery, you can switch Off the screen by moving the switch (6) to position "LCD Off". You will
only get the sound from the speaker.
• The condition of the rechargeable battery pack is shown by the battery level indicator (4). When the
battery power is being consumed, the indicator turns red or orange.
a. 2 6V C adapter for transmitter and receiver
b. Charging base
c. Transmitter
d. Receiver
e. Li rechargeable battery pack (installed in receiver unit)
f. User manual
c
OPER TION
CCESSORIES
d
+
+
VOL
-
-
B BY MONITOR VISIO C RE • Instruction Manual
b
e
a
f
11

Publicidad

Tabla de contenido
loading

Tabla de contenido