on. If the snore stopper cannot be switched on, the battery in it is flat. Re-
charge the battery as described in Chapter "6. Charging the battery". After
a short time, the operation light switches off so that it does not disturb you
in the night.
2. Attach the snore stopper to your left or right ear as shown.
3. Go to bed.
4. As soon as you get up, switch off the snore stopper. To do this, press and
hold the ON/OFF button on the snore stopper for three seconds. A short
vibration confirms that the snore stopper has been successfully switched off.
Initially, it may take up to 7 days until you are accustomed to the device.
6. Charging the battery
1. Open the cover on the micro USB connection of the snore stopper.
2. Connect the charging cable included in delivery to the snore stopper and
a computer that is switched on. Alternatively, connect the charging cable
with the snore stopper and the mains adapter. Insert the mains adapter
into a suitable socket.
3. Whilst charging, the operation light flashes green. As soon as the battery is
fully charged, the operation light will remain green.
4. It usually takes approx. 3 hours to fully charge the battery. As soon as the
battery is completely charged, remove the charging cable from the computer
or the socket and the mains adapter and the snore stopper.
5. When the battery is fully charged, the battery life is approx. 4–5 days. The
operation light turns red as soon as the battery capacity is below 41%.
7. Transferring data to your smartphone
To transfer the recorded data from your snore stopper to the "beurer SleepQuiet"
app, proceed as follows:
1. Activate Bluetooth
2. Open the "beurer SleepQuiet" app. Press the ON/OFF button on the snore
stopper. The recorded data is now transferred to the smartphone. For a large
volume of data, this may take some time.
on your smartphone.
®
16