Sensitivity Adjustment; Technical Data - Cardin T624 Instrucciones De Uso

I GB
MODIFYING THE PAUSE TIMES
This procedure allows you to modify the pause time set during a previous programming procedure.
This operation must be carried out with the gate closed.
1) Press the PROG button (part. 15, fig. A) and hold it down until the Led LD1 remains lit (part. 18, fig. A)
2) Press the PROG button again, led LD1 will start to flash and the ECU will begin to memorise the pause time.
3) Once the desired pause time has elapsed, press the PROG button. Led LD1 will switch off and the procedure will terminate.

SENSITIVITY ADJUSTMENT

According to the standard EN 12445 every automation installation must pass the impact test measured with the specific
instrument.
Carry out the impact test and adjust the motor force by rotating the trimmer (part. 21, fig. A).
If this is not sufficient to remain within the boundaries of the graph supplied by the standards in force, we advise you to install a
rubber protective edge at the head of the gate so as to soften the impact.
If you have adjusted the sensitivity setting and added a rubber profile to the head of the gate and you are still unable to satisfy
the standards in force, you will need to add other safety devices such as a sensitive safety edge to the moving part of the gate.
MODIFYING AND CONTROLLING SETTINGS USING PRG-Link (optional)
The PRG LINK system is a WI-FI interface dedicated to
programming, control and diagnostics of the latest
generation ECU's.
Using PRG LINK and its dedicated software application,
the operator takes advantage of a powerful Wi-Fi
network that allows him to intervene on the ECU without
having to directly access the dip-switches.
A laptop, tablet or smart phone is all that's needed to run
quick and precise diagnostic processes.
An advantageous solution for all those who have to
manage installations on a daily basis and in the future
would like to do so by means of a long-distance Wi-Fi
connection.
To cancel all settings carried out with PRG-Link proceed as follows:
1) Hold the PROG. Button (det. 15, fig. A) down for about 3 seconds until led LD1 (det. 18, fig. A) lights up
2) Press and hold down P3 for about 10 seconds until LD1 remains lit.
3) the parameters have been reset and you may release button P3.

TECHNICAL DATA

Mains power supply
Maximum absorption
Number of motor outputs
Motor power supply
Maximum motor power
Protection class
Operating temperature
DISPOSAL
This product ismade up of various components that could contain pollutants.Dispose of properly!
Make enquiries concerning the recycling or disposal of the product, complying with the local laws in
force.
53
U.M.
Vac/Hz
A
V
VA
IP
°C
T624
230/50-60
2
2
24dc
2 x 180 (1 x 300)
56
-20 +55