Hitachi W 6V3 Instrucciones De Manejo página 8

English
(3) Remove the carbon brushes from the brush holders.
Assembly
(1) Insert the new carbon brushes into the brush holders.
(2) Insert the brush holders together with the carbon
brushes into the brush holder chambers in the
housing.
(3) Ensure that the lead wire and other parts are properly
positioned, and that there is no possibility of the
lead wire coming in contact with the armature or
other moving parts.
(4) Reinstall the handle cover while ensuring that the
internal wiring does not become pinched between
the handle cover and the housing, and secure the
handle cover with the three screws.
CAUTIONS
Be sure to follow the above assembly procedures
exactly. Should the internal wiring contact the
armature or become pinched between the handle
cover and housing, a serious risk of electric shock
to the operator would be created.
Do not tamper with parts other than those necessary
to effect carbon brush replacement.
NOTE
Due to HITACHI's continuing program of research and
development, the specifications herein are subject to
change without prior notice.
IMPORTANT
Correct connection of the plug
The wires of the mains lead are coloured in accordance
with the following code:
Blue:- Neutral
Brown:- Live
As the colours of the wires in the mains lead of this tool
may not correspond with the coloured markings
identifying the terminals in your plug proceed as follows:
The wire coloured blue must be connected to the terminal
marked with the letter N or coloured black. The wire
coloured brown must be connected to the terminal marked
with the letter L or coloured red. Neither core must be
connected to the earth terminal.
NOTE
This requirement is provided according to BRITISH
STANDARD 2769 1984.
Therefore, the letter code and colour code may not be
applicable to other markets except United Kingdom.
Information concerning airborne noise and vibration
The measured values were determined according to
EN50144.
The typical A-weighted sound pressure level: 85 dB (A).
Wear ear protection.
The typical weighted root mean square acceleration value
does not exceed 2.5 m/s
6
2 .