Multiplex SOUFFLEUR Manual De Instrucciones página 13

Vario tone On / Off using the
Set button does not work
Telemetry values are spoken
incorrectly
Spoken messages cannot be
controlled from the transmitter
Operating Instructions - Souffleur
You are using "Altitude difference message",
but the altitude value is constant (e.g. model
is on the ground).
You have assigned a servo channel to the
vario address as switch. In this arrangement
the unit ignores the On / Off function of the
Set button.
In the Souffleur you have set the vario tone
version to "Silence at inherent sink rate",
and your model is currently flying between
inherent sink and the initial phase of climb.
You have assigned a particular sensor
address more than once.
You are using "Announce at Timer2", but the
set time is not sufficient.
In the Souffleur you have assigned one of
the servo channels 13 to 16 under "Switch",
but your M-LINK transmitter is operating with
"Fast Response = On".
The spoken message starts as soon as your
model is moving, and the set altitude difference is
exceeded.
Either switch the vario On / Off from your RC sys-
tem transmitter, or erase the switch assignment in
the Souffleur.
For more information on assigning switches please
refer to the Help system in the MULTIPLEX
Launcher PC program.
The vario tone will be generated when the rate of
climb or descent increases.
Alternatively: select a different vario tone setting in
the Souffleur.
Ensure that each address is only assigned once
when setting up your sensors.
For the Timer: select a time which allows all voice
messages to be generated completely before the
timer restarts the message. Note that the spoken
message may vary in length according to alarms
or "Announce at altitude difference".
Only twelve servo channels are transmitted when
Fast Response is On. Either switch Fast Res-
ponse off, or use one of servo channels 1 to 12 as
switch.
Page 12