Transferring Data To Your Smartphone; Cleaning And Maintenance - Beurer SL 60 Instrucciones De Uso

5. When the battery is fully charged, the battery life is approx. 2 to 3 days.
The operating light turns red as soon as the battery capacity is below 41%.

7. Transferring data to your smartphone

To transfer the recorded data from your snore mask to the "beurer Sleep Quiet"
app, proceed as follows:
1. Activate Blue tooth
2. Open the "beurer SleepQuiet" app.
3. Slide the ON/OFF switch on the snore mask to "ON". The display for Blue­
tooth flashes blue. As soon as the snore mask is connected to your smart-
®
phone, the Blue tooth
ed data is now transferred to the smartphone. For a large volume of data,
this may take some time. After data has been transferred, the Blue tooth
display will go out.

8. Cleaning and maintenance

The control unit of the snore mask is re-
movable. To do this, use both hands to
pull the control unit from the snore mask,
following the direction of the arrow on
the underside.
Please note that removing the control
unit too frequently has a negative effect
on the product. The control unit should
only be removed in order to wash the
snore mask.
IMPORTANT
• Before cleaning, always remove the control unit from the snore mask.
Otherwise there is a risk of damage.
IMPORTANT
• The control unit of the snore mask must never come into contact with water
or other liquids. This may cause damage.
When cleaning the control unit use a cotton pad soaked in 70% isopropyl al-
cohol. Do not use any chemical or abrasive cleaning agents.
on your smartphone.
®
display will continuously illuminate blue. The record-
®
18
®