General Warnings For The Installer; Conservation Of Documentation; Operating Limits; Safety Symbols - AERMEC Omnia UL R Serie Manual Del Usuario

EN

OPERATING LIMITS

Model OMNIA UL_R - UL_RI
Ambient temperature limits 0°C<Ta<40°C
Ambient humidity maximum
limit
Maximum water inlet tem-
perature
Maximum opera ng pressure
Protec ve ra ng

SAFETY SYMBOLS

Danger
Moving parts
Electrical danger
22
1.

GENERAL WARNINGS FOR THE INSTALLER

26-36
The Omnia UL_R and UL_RI units are manufactured in
accordance with recognised technical standards and
safety regulations. It is a terminal unit which contains,
<85% RH
within one device, the best solution for heating, cool-
ing and dehumidification. They must be used for the
80°C
purpose for which they are intended and compatible
with their performance characteristics. All contractual
8 bar
and extra-contractual liabilities for damage caused to
IP20
persons, animals or objects or through errors of instal-
lation, control or maintenance or from improper use
are excluded by the Company. Any uses not expressly
indicated in this manual are not permitted.
1.1.

CONSERVATION OF DOCUMENTATION

1. Consign the instructions with all the complemen-
tary documentation to the user of the unit who
will assume responsibility for the conservation
of the instructions so that these are always avail-
able in case of need.
2. Carefully read this document. The execution of
all the works must be carried out by qualified
personnel, in accordance with the national
regulations.
3. Do not modify or tamper with the unit as this
may cause danger for which the manufacturer
will not accept any responsibility for any dam-
ages caused. The warranty is voided if the above
instructions are not followed.

Nameplate

Omnia UL_R/UL_RI 26-36
1.2. SAFETY WARNINGS AND INSTALLATION
STANDARDS
1. The unit must be installed by a competent and
qualified technician, and in accordance with the
legislation applicable in the country of installa-
tion.
Aermec assumes no responsibility for damage
caused by failure to observe these instructions.
2. Before commencing any works it is necessary
to CAREFULLY READ THE INSTRUCTIONS AND
MINIMISE ANY RISKS BY TAKING APPROPRIATE
SAFETY PRECAUTIONS. All relevant personnel
must be made aware of the procedures and
possible risks that may arise at the time of instal-
lation of the unit.
3. The unit must be installed in such a way to make
maintenance and/or repair functions possible.
1.3.

PRODUCT IDENTIFICATION

The fan coil units are identified by:
− PACKING LABEL
that records the product iden fi ca on label
− NAMEPLATE
WARNING:
The tampering, removal or absence
of the identification label renders dif-
ficult any operation of installation or
maintenance.
Aermec cod. 6976420_00 13.05