CoolMatic
2.1
General safety
DANGER!
D
Danger of fatal injuries!
When using the appliance on boats: if the appliance is
powered by the mains, ensure that the power supply has a
residual current circuit breaker!
WARNING!
!
Before you start up the appliance for the first time, check that the
operating voltage matches the battery voltage (see type plate).
If the connection line of this device is damaged, it must be re-
placed with a special connection line which is available from the
manufacturer or customer service.
Have a trained technician do the installation in wet rooms.
Do not operate the appliance if it is visibly damaged.
This appliance may only be repaired by qualified personnel.
Improper repairs can lead to considerable hazards.
NOTICE!
A
Warning: do not open or damage the refrigerant circuit under
any circumstances.
Set up the appliance in a dry location where it is protected
against splashing water.
Do not place the appliance near naked flames or other heat
sources (heaters, direct sunlight, gas ovens etc.)
Ensure that the ventilation slots are not covered.
Do not store any explosive substances, such as spray cans with
propellants in the device.
EN
Safety instructions
37