Dometic CK400 Instrucciones De Montaje página 22

Mounting the extractor hood
➤ Place the fan on the opening and mark the six screw holes.
➤ Apply a thin ring of a permanently elastic sealing material around each
hole.
➤ Put the rubber seal (fig. 5 4, page 4) into the groove on the underside of
the fan.
I
NOTE
Pull the fan on tightly enough that the rubber seal is seamlessly in
contact with the roof.
➤ Attach the fan (fig. 5 3, page 4) with the six included bolts (4.2 x 25).
➤ Attach the roof hood (fig. 5 2, page 4) with the three included bolts
(3.5 x 9.5).
➤ Attach the cover cap (fig. 5 1, page 4) with the three included bolts
(4.2 x 13).
6.2 Mounting the extractor hood
!
WARNING!
 Attach the extractor hood preferably over the cooking zone
and install it in a a suspended cabinet.
 The distance between the gas hob flame and the extractor
hood must be at least 50 cm.
➤ Choose a suitable installation location in the interior for the extractor
hood.
➤ Draw the location and size of the section of 381 x 142 mm on the bottom
of the suspended cabinet (fig. 4, page 3).
➤ Pre-drill and cut out the section carefully with a keyhole saw or similar
tool.
➤ Insert the extractor hood from below into the cabinet and secure it with the
four included bolts (3.5 x 13) (fig. 6, page 4).
➤ Attach the hose (fig. 6 3, page 4) to the extractor hood (fig. 6 5,
page 4) and the fan (fig. 6 1, page 4) with the hose clips (fig. 6 2 and
4, page 4).
➤ Insert the filter (fig. 2 1, page 3) into the extractor hood.
22
Dometic CK400
EN