Troubleshooting - Triton JOF 001 Instrucciones De Uso Y De Seguridad

Troubleshooting

Problem
Shutter on Power Switch with Lock-Out Cover (3) not
releasing
Inaccurate cutting profile
Router will not operate
Router runs or cuts slowly
Excessive vibration
Heavy sparking occurs inside motor housing
Micro Winder (8) "clicks" or not adjusting
Makes an unusual sound
GB
8
Possible cause
Router is plunged to full depth – in collet lock position
Depth Stop not correctly adjusted
Incorrectly fitted or loose router bit/Collet (5)
No supply of power
Brushes worn or sticking
Power Switch with Lock-Out Cover (3) is faulty
Motor components faulty or short circuited
Blunt or damaged cutter
Speed Controller (1) set low
Motor is overloaded
Incorrectly fitted or loose router bit
Bent or damaged router bit
Brushes not moving freely
Damaged or worn motor
Plunge Lock Lever (7) engaged
Reached end of adjustment range
Mechanical obstruction
Damage to internal windings
Solution
Reduce plunge depth
Ensure that the Depth Stop corresponds to the maximum
amount of cut permitted by the Turret Stops (9)
Tighten router bit/Collet and cutter assembly
Check that power is available at source
Disconnect power, open Brush Caps (20) and ensure brushes
are not damaged or heavily worn
Have the tool serviced by an authorised Triton service centre
Have the tool serviced by an authorised Triton service centre
Resharpen or replace cutter
Increase variable speed setting
Reduce pushing force on router
Refit or tighten router bit
Replace router bit
Disconnect power, remove brushes, clean or replace
Have the tool serviced by an authorised Triton service centre
Release Plunge Lock Lever
Reset Micro Winder and set depth with the Depth Stop (11)
Have the tool serviced by an authorised Triton service centre
Have the tool serviced by an authorised Triton service centre