Troubleshooting And Fault Correction; Disposal; Technical Data; Wide Jet - Walther PILOT BOND 2K Manual De Servicio

7

Troubleshooting and fault correction

Fault Cause
Material needle or nozzle dirty
Material needle or nozzle
damaged
Gun drips
Needle spring (item 13) not in
Component A
order, possibly broken
Material needle does not
agree with nozzle size
Adjusting screw (item 9) tur-
ned too far back
Component B is damaged
Gun is dripping
(Component B)
Component B is leaky
Level in material tank too low
Pulsating or
unsteady spray jet
Material nozzle is loose or
damaged
Valve spring (Item 6.3) or
Gun keeps blo-
Valve shaft (Item 6.2) dama-
wing in off-position
ged
8

Disposal

Waste spraying media and waste material from cleaning and servicing must be
disposed of in accordance with all applicable local and national regulations.
Remedy
Clean
Replace, according to
5 Converting / repairing the
spray gun
Remove material needle
and replace spring
Make sure diameters are
the same
Slightly turn in the adju-
sting screw (clockwise)
Replace
Replace
Refill material (see
operating instructions of
system manufacturer)
Tighten
Replace
32
9

Technical data

Net weight:
Connections
Atomizer air:
Material connection comp. A:
Material connection comp. B:
Nozzle orifice comp. A:
Nozzle orifice comp. B:
Air Cap:
Pressure ranges
intake air pressure:
material pressure:
recommended atomizer air pressure
max. operating temperature:
Sound level
(measured at approx. 1 m
distance to the spray gun)
Air consumption:
Atomizer air pressure Round spray jet
1 bar
2 bar
3 bar
4 bar
5 bar
Right to effect technical changes reserved.
470 g
Hose connection 8x6 mm ø
Hose connection 8x6 mm ø
Hose connection 4x2,5 mm ø
0,8 / 1,0 / 1,2 mm ø
0,3 / 0,4 / 0,5 mm ø
Round spray jet
Wide spray jet
max. 5 bar
max. 3 bar
ca. 1 - 2 bar
43°C
83 db (A)
Wide spray jet
in l/min. in l/min.
93 130
155 210
205 290
260 360
310 440
33