Important Safety Instructions; Transportation; Preparation; Installation - INFOSEC UPS SYSTEM E6 LCD RT Evolution IK IEC Manual De Instrucciones

1. Important Safety Instructions:

Please comply with all warnings and operating instructions in this manual
strictly. Save this manual properly and read carefully the following instructions
before installing the unit. Do not operate this unit before reading through all
safety information and operating instructions carefully
IMPORTANT!
Installing and connecting UPSs in a way that does not comply with accepted practices
releases Infosec Communication from any liability.

1-1. Transportation

Please transport the UPS system only in the original package to protect against shock

and impact.

1-2. Preparation

Condensation may occur if the UPS system is moved directly from cold to warm

environment. The UPS system must be absolutely dry before being installed. Please
allow at least two hours for the UPS system to acclimate the environment.
Do not install the UPS system near water or in moist environments.

Do not install the UPS system where it would be exposed to direct sunlight or near

heater.
Do not block ventilation holes in the UPS housing.

Do not block air ventilation holes in the UPS housing. The UPS must be
installed in a location with good ventilation or with air-conditioning. Ensure
enough space on each side for ventilation. Ideally, the room temperature
doesn't exceed 20°C and 0-90% non-condensing humidity.

1-3. Installation

Do not connect appliances or devices which would overload the UPS system (e.g.

laser printers) to the UPS output sockets.
Place cables in such a way that no one can step on or trip over them.

Do not connect domestic appliances such as hair dryers to UPS output sockets.


The UPS can be operated by any individuals with no previous experience.
Connect the UPS system only to an earthed shockproof outlet which must be easily

accessible and close to the UPS system.
Please use only VDE-tested, CE-marked mains cable (e.g. the mains cable of your

computer) to connect the HV UPS system (220V/230V/240V) to the building wiring
outlet (shockproof outlet).
Please use only VDE-tested, CE-marked power cables to connect the loads to the HV

UPS system (220V/230V/240V).
When installing the equipment, it should ensure that the sum of the leakage current

of the UPS and the connected devices does not exceed 3.5mA.
NOTE for LV models :
Unit should provide external disconnect device at input and output side.

The disconnection device should be chosen based on VDE/EN/UL approval, rated

240V, 250A and should break line and neutral conductors - four poles for three
INFOSEC UPS SYSTEM – 15 rue du Moulin – 44880 Sautron – France – www.infosec-ups.com
Hot Line Tel: +33 (0)2 40 76 15 82 – fax: +33(0)2 40 94 29 51 – hotline@infosec.fr – 04 17 AA 59 205 87
34