Environmental Protection, Disposal - AL-KO LHS 5500 Manual De Instrucciones

3. Check the seals (Illus. 11-1) for damage and
replace if necessary.
Warning!
Refill only with viscosity class HLP 46
hydraulic oil.
An oil change is not necessary.
Malfunction
The splitting column does
not move out/in
The splitting blade does
not exert any force
Motor does not start
Hydraulic pump makes a
whistling noise, the split-
ting column moves with a
jerking motion
The green activation
button does not engage
after pressing
Motor becomes exces-
sively hot

Environmental protection, disposal

Do not dispose of old units in household waste!
The packaging, unit and accessories are made of materials that can be recycled and
should be disposed of in a suitable manner.
Accessories
See Illus. B for available accessories for all log splitters.
Cause
Motor rotation direction is incorrect
(in case of LHS 7000)
Too little hydraulic oil
Too little hydraulic oil
Trigger rod is bent
Thermostatic switch has tripped
The mains plug or socket is defective Have checked by electrical spe-
Cable defective
Too little hydraulic oil
No neutral conductor connected
Defective fuse (only in case of
LHS 7000)
A phase is missing (only in case of
LHS 7000)
Switch is defective
Cable cross section is too small
A phase is missing (only in case of
LHS 7000)
GB 5
Malfunctions
Switch off the log splitter and pull out the mains
power plug in the event of malfunctions occur-
ring. Engage a specialist firm or workshop to
remedy malfunctions that cannot be rectified on
the basis of the following table.
Remedy
Check direction of rotation
Top up hydraulic oil
Top up hydraulic oil
Have
workshop
Wait until the motor has cooled
down.
cialist
Replace
Top up hydraulic oil
Have cable and electrical power
mains
specialist
Have cable checked by electrical
specialist
Replace
Use cable with larger cross
section
Have cable and electrical power
mains
specialist
Translation of original user instructions
Log splitter
checked by specialist
checked by electrical
checked by electrical