Safety And Protective Devices; Motor Protection Switch; Mains Cable; Electrical Requirements - AL-KO KHS 3704 Manual De Instrucciones

GB
2.3

Safety and protective devices

WARNING!
Risk of injury
Defective and disabled
safety and protective
devices can lead to
serious injury.
■
Have any defective
safety and protective
devices repaired.
■
Never disable safety
and protective devices.
2.3.1

Motor protection switch

The motor protection switch switches off the
motor if the log splitter is overloaded.
Do not deactivate the function of the motor
protection switch.
If the motor protection switch has switched off the
log splitter, proceed as follows:
1. Disconnect the log splitter from the mains.
2. Determine the cause of the overload.
3. Allow the log splitter to cool down for several
minutes, then connect to the mains again.
4. Switch on the log splitter.
30
2.3.2

Mains cable

WARNING!
Risk of injury from
electric shock
A defective mains cable
can result in serious
injuries due to electric
shock.
■
Ensure that the mains
cable is not damaged or
severed.
■
Use only rubber-sheathed cables of quality
H07RN-F according to VDE 0282 Part 14
with a conductor cross section of at least
2.5 mm².
■
The maximum permissible cable length is
10 m. A longer cable impairs the motor power
and hence the performance and function of
the log splitter.
■
Mains cable, mains plug and coupling socket
must be undamaged. A defective mains
cable (e.g. with cracks, cuts, crushed or
kinked points in the insulation) must not be
used.
■
Repairs to the mains cable, mains plug and
coupling socket may only to be carried out by
qualified electricians.
■
Do not expose plug connectors to moisture.
■
If the mains cable is damaged, immediately
disconnect it from the mains.
2.4

Electrical requirements

■
AC 230 V / 50 Hz
■
Minimum cross-section of the mains cable =
2.5 mm²
■
Minimum fusing of the mains connection =
16 A
KHS 3704 | KHS 5204 | KHS 8552
Product description