Rear Panel - Fender Hot Rod DeVille ML Manual De Instrucciones

S. POWER CORD — Connect to a grounded outlet in accordance
with the voltage and frequency ratings specified on the rear
panel of your amplifier.
T. FUSE — The fuse protects the unit from electrical faults.
Replace fuses only with the type and rating specified on the
fuse holder. If the unit repeatedly blows fuses, have the unit
tested at an authorized Fender® Service Center.
U. INTERNAL SPEAKER JACK — One of the following speaker
configurations (internal or external) must always be connected
when the unit is ON to prevent damage to the amplifier:
1. 1.
2. 2.
* *
3. 3.
* Insert an open plug (without speakers connected) into the
Internal Speaker jack {U} for configuration three (3).
V. EXTERNAL SPEAKER JACK — This jack is wired in parallel with
the internal speaker jack and must only be used with a speaker
load or an open plug connected to the internal speaker jack, as
shown above in the INTERNAL SPEAKER JACK diagram.
TYPE:
POWER REQUIREMENT:
POWER OUTPUT:
INPUT IMPEDANCES:
PREAMP OUTPUT IMPEDANCE:
POWER AMP INPUT IMPEDANCE / SENSITIVITY:
TUBES:
FUSE:
SPEAKERS:
ACCESSORIES (INCLUDED):
DIMENSIONS:
WEIGHT:
10

Rear Panel

2
Specifications
PR 247
180W
60W into 8Ω or 4Ω at 5% THD
INPUT 1: 1MΩ
1.5kΩ max
200mV for clipping / 54kΩ
One: 7025/12AX7A ECC83S GT-GOLD (P/N 0074287400)
Two: 6L6GC/5881WXT GT-6L6-R (P/N 0039214100)
F3AL, 250V fuse (100V–120V versions)
Two: 12" Celestion® G12V-70 (P/N 7700343000)
2-button Footswitch, Volume Select/Boost (P/N 7705958000)
HEIGHT: 21 in (53.3 cm)
62 lb (28.2 kg)
Product specifications are subject to change without notice.
W. OUTPUT TUBES GT6L6R — Your new Fender amplifier comes
equipped with the highest quality tubes available, sourced
from various manufacturers worldwide. Because of occasional
irregularities in supply, the specific tube type used in each
amplifier is subject to change without notice.
CAUTION, SHOCK HAZARD: To replace the power tubes please
contact an authorized service center for this periodic maintenance.
Removing the back panel exposes dangerous high voltage
components and is not a user-serviceable procedure.
When replacing power tube sets with the same rating and type
of tubes, no adjustment should be needed. When tweaking the
performance characteristics of your amplifier with a different
power tube set, you should have a qualified service technician
re-bias your amp to meet the optimum performance specifications
for the new tubes.
In the future, if you experience any sonic performance issues with
your amp, or have further questions concerning the tubes in your
amplifier, please contact your Fender dealer or authorized service
center.
X. PREAMP TUBE STABILIZER — A
stabilizer is installed around the preamp
tubes to minimize the tube microphonics
that normally develop over time. The
stabilizer can be used with all preamp tubes
compatible with your Hot Rod amplifier.
INPUT 2: 136kΩ
Two: 7025/12AX7WC RUSN FENDER (P/N 0070228000)
F1.6AL, 250V fuse (220V–240V versions)
WIDTH: 24.25 in (61.6 cm)
vibration-absorbing
Fitted cover (P/N 0050698000)
DEPTH: 10.75 in (27.3 cm)