Air Intake - HeatStar GSP45 Instrucciones De Operación

Air Intake

Service Door
Burner Box Contains the electrical components (i.e. blower motor, power transformer, etc.)
and gas distribution components (i.e. gas valve, etc.) that make the heater work.
There are no owner serviceable items contained in this box.
Front Fixed Provides rigid support and mounting surface for the reflector. Holes are provided in
Hanger the upper corners and center of the bulk
Reflector The reflector is made from formed aluminum and reflects the radiant energy
downward to the space to be heated.
Heat Exchanger A U-shaped tube through which the heated products of combustion pass.
Rear Movable Provides support for the heat exchanger and reflector at the end that is furthest
Hanger from the burner box. The support may be moved (within limits) to accommodate
hanging of the unit.
Service Door To be removed only by a licensed contractor. Removal of this service door provides
access to the electrical and gas distribution components.
Intake Vent Accommodates a 3" diameter combustion air inlet duct that delivers fresh air to
the burner.
Exhaust Vent Accommodates the air-venting duct that carries the products of combustion to be
vented outdoors.
Nipple - ½" NPT Point at which the gas supply is connected to the heater.
Power Cord Includes a three prong plug that must be connected to a dedicated and properly
grounded three prong ceiling outlet.
Burner Box
Vent
Gas-Fired Low-Intensity Infrared Heater
Front Fixed Hanger
Reflector
Heat Exchanger
4
Operating Instructions and Owner's Manual
Rear Movable Hanger