Smartphone App; How To Connect Your Nrgkick Charging Unit To The Nrgkick App; Hints For Use - DiniTech NRGkick Manual De Instrucciones

7. Smartphone App

The "NRGkick" App can be downloaded from Google Play and the Apple App Store. This
provides enhanced options for controlling the charging unit and monitoring the charging
process.
The App is fairly self-explanatory. When establishing a Bluetooth connection between your smartphone
and NRGkick take account of the following:

7.1 How to connect your NRGkick charging unit to the NRGkick App

•
Connect the charging unit to the power supply
•
Open the NRGkick App on your Smartphone while being close to the charging unit. The charging
unit is displayed in the NRGkick App.
•
Tap the icon to connect to the charging unit
Note: Upon opening the NRGkick App the first time you are prompted to change the access code for
security reasons. The factory-set value for both charging unit and NRGkick App is „1234". You can also
change the access code anytime later via the settings menu.
If different access codes have been assigned to charging unit and NRGkick App (e.g. when using a new
Smartphone) you can still connect to the charging unit but cannot change parameters (e.g. changing the
charging current).
In this case, you are prompted to enter your access code which is already set in the NRGkick. If you have
forgotten it, you can reset the access code of the charging unit to the factory-set value of "1234" by
proceeding as described in point 7.2. Afterwards also assign the same access code "1234" to the NRGkick
App via the settings menu.

7.2 Hints for Use

A short oscillating flashing light usually signals that a parameter has been sent from the smartphone to the
charging unit. If the Access Codes for the smartphone and charging unit do not match, all LEDs will briefly
flash simultaneously.
If the user has enabled a limiting function via the smartphone (e.g. energy limit or stop command), the
green LED will flash.
It is possible to connect several charging units to the same smartphone (not at the same time). The
different Access Codes for the individual charging units will be saved on the smartphone and assigned
separately.
The Access Code for the charging unit can be reset as follows:
1) Press the selection button and keep it held down.
2) Connect the charging unit to the power grid (button stays pressed).
3) As soon as the LEDs illuminate, release the button.
4) The reset takes approximately 1 minute and is signaled by various flashing sequences.
5) Finally, the default code ´1234´ will be assigned to the charging unit again.
Remark: The Access Code can only be reset if the vehicle connector is unlocked and unplugged to
prevent the unit being tampered with by unauthorized persons.
Ver.: 1810-11
EN
9