Intended Use - DiniTech NRGkick Manual De Instrucciones

The charging unit should be hanging from the power grid socket when charging is in progress to allow
water to run off the charging unit. Protect the unit from water intrusion!
If an adapter plug is used, never set a higher charging current than
1) the maximum current the adapter is Approved for.
2) the maximum current the upstream installation and socket are Approved for.
If the power supply socket feels hot when charging is in progress, replace this socket immediately!
Never use force to pull on the cable ends of the charging unit!
Never connect or disconnect plug connections between grid connector, plug adapter or vehicle inlet while
the NRGkick is in charging mode!
Their use as a rope for lifting or pulling mechanical loads or for wrapping or tying up objects is strictly
prohibited!
The charging unit may only be operated in accordance with its intended use!
When removing the cable from the socket pull on the connector, never the cable!
Protect the charging unit and the charging cable from mechanical damage (running over, pinching or
kinking) and the electrical contact area from heat sources, dirt and water!
Only use adapters and accessories supplied by DiniTech GmbH with the charging unit or those that are
approved by DiniTech GmbH!
The plug adapters contain a Neodymium magnet which may not be brought into direct body contact with
heart pacemakers out of safety reasons.
The NRGkick contains a Bluetooth Low Energy module which may not be brought into direct body contact
with heart pacemakers out of safety reasons.
EN
In the following countries the charging current may not be set higher than 8A if a Schuko adapter plug is
used:
Denmark, Finland, France and Switzerland
If a Schuko adapter plug is used, the weight of the charging unit must not put strain on the socket. Relieve
the strain on the cable (e.g. by placing the unit on something or hanging the cable over a hook).
During a single phase charging operation within a 3-phase-grid, the requirements of the grid operator for
asymmetric grid loads needs to be considered. The charging power may not be set to a higher value than
the maximum single phase power drain permitted by the grid operator.

4. Intended Use

The charging and all included accessories unit may only be used to charge the drive battery of an electric
or plug-in-hybrid vehicle. Section 5 "Product Description" describes operation of the charging unit.
Any other use will be considered as improper use. DiniTech GmbH does not assume liability for any damage
that results from such improper use!
Intended use includes following the instructions in this manual as well as observance of all labeling such as
type plates, warning notices, current limit marks, display symbols and ambient conditions.
4 Ver.: 1810-11