Manual Version - Numark iCDX Manual De Referencia

USB H.I.D. Mode
You can also connect the iCDX to a computer via USB to use the iCDX as a controller for software
programs that are compliant with the USB Human Interface Device protocol such as Numark Cue DJ
software. Check with your software manufacturer to find out if your software supports a USB HID
controller.
To activate HID mode, connect a USB cable from the iCDX USB SLAVE connector to a USB port on your
computer. Then press SRC and turn the parameter knob to select USB_HID.
iCDX Upgrade Procedure
1. Download and unzip the operating system update .zip file.
2. Burn the .iso file to a CD as a disc image.
3. If there is a CD in the iCDX, please remove it and power off the unit.
4. Power up the iCDX while holding the PROG button.
5. The display will say "No Disc". Insert your burned operating system CD.
6. The iCDX will read the CD for a few seconds and then it will eject it. DO NOT POWER OFF
THE iCDX!
7. After the CD is ejected the update process will begin. On the display you should see a series
of numbers counting up as the update is applied. Please wait for the update to complete –
this may take a few minutes.
8. When the update is complete, the display should say "No Disc". You can now return to normal
operation.
Specifications
Supported Disc Type: Redbook CD, CDR, CDRW, DVD(2 layer), MP3 CD.
Time Display: Track Elapsed, Track Remain, Total Remain
Sampling Frequency: 44.1 kHz
Freq Response: 20Hz to 20kHz
THD + N: Less than 0.03%
SNR (IHF-A): > 80dB
Dynamic Range: > 75dB
Output Level: 1.2V RMS
Pitch Control Range: +/-6, 12, 25, 100%
Pitch Bend: +/-16% rotary, buttons +/- 16%
Digital Output: Type 2, form 1 S/PDIF
(Sony/Phillips Digital Interface Format)
Dimensions: 290(L) X 241.5(W) X 90(H) mm
Weight: 3.15 kg
Power Supply: 100-240VAC, 50/60Hz
Power Consumption: 22W

MANUAL VERSION 2.0

11