Numark iCDX Manual De Referencia página 7

29.
PITCH / KEYLOCK - The pitch button
controls the range of the pitch fader as well
as enabling and disabling key lock mode.
Press and release the pitch button to cycle
through pitch fader settings of +/- 6%, 12%,
25% and 100%.
pitch fader by pressing the pitch button
again after selecting 100%.
The other function of this button is key lock.
To engage key lock mode, hold the pitch
button for two seconds. This feature allows
you to change the speed of the song without
changing the key. The key of the song will
lock to whatever position the pitch fader is at
when key lock is engaged.
manually change the key of a song by
holding the PITCH button while turning the
parameter knob.
30.
PITCH BEND - Allows you to briefly adjust
the speed of the music faster or slower for
as long as the button is held.
quick speed adjustments to help match the
beats of two songs that might be at the
same tempo but have beats that hit at
slightly different times.
31.
USB MASTER - Connect your favorite USB
storage device to this connector to allow the
iCDX to read and play back your music files.
The iCDX only supports the mp3 format so
please make sure that your audio files are
encoded as mp3s if you would like to use
them with the iCDX,
supports the HFS+ and FAT files systems.
NTFS is not supported.)
32.
USB SLAVE - Connect the iCDX to a
computer via this USB jack and your iCDX
can be used as a USB controller device using
the USB Human Interface Device protocol.
33.
OUTPUT - Use these RCA jacks to connect
the iCDX to a speaker system or to any
device that is designed to accept an RCA line
level connection.
34.
DIGITAL OUT - This RCA connector will
allow you to send a digital audio signal to
any device designed to accept a S/PDIF
(Sony/Phillips Digital
signal. You can also connect the digital
output to a karaoke decoder to reproduce
the graphics from CD+G discs.
You can also disable the
You can also
Useful for
(Note: The iCDX
Interface Format)
35.
FADER START - Use this connector to plug
into your fader start compatible mixer or
remote switch.
To use this connector for fader start, use a
fader start cable to connect to a fader start
compatible mixer. Every time you move the
crossfader on the mixer to the side that the
unit is on, it will start playing.
move the fader away from that side, the unit
will stop.
playback again.
Foot switches can also be attached to this
jack for creative mixing techniques and can
be found at most music shops.
plugs are often 1/4", so you may need to
use a 1/8" adapter.
There are two types of footswitches that will
work with this unit.
on/off pushbutton switch and is generally
used for switching channels on a guitar
amplifier. The second type is a momentary
footswitch commonly used as a keyboard
sustain pedal.
36.
RELAY - Relay play allows two compatible
CD players to alternate play from one unit to
the other and back as the tracks end.
use the relay feature, connect one end of
your relay cable here and the other end to
the relay jack of your other CD player.
To turn relay mode on and off, hold the
MODE button and turn the parameter knob.
37.
POWER PLUG CONNECTOR - Attach the
cable from the power supply to this jack.
The connector is keyed to fit only one way,
so make sure that the slot in the power cable
is facing downward when you screw in the
connector.
38.
POWER BUTTON - Press this to turn the
unit on and off.
5
When you
Moving the fader back will start
Connector
The first is a typical
To