Insert The Batteries - TFA Dostmann 60.2529.54 Instrucciones De Uso

TFA_No. 60.2529_Anleit_04_20 28.04.2020 14:47 Uhr
Radio-controlled alarm clock with monthly calendar
Caution!
Risk of injury::
• Keep this instrument and the batteries out of reach of children.
• Batteries contain harmful acids and may be hazardous if swallowed. If a battery is swallowed, this can lead to serious internal
burns and death within two hours. If you suspect a battery could have been swallowed or otherwise caught in the body, seek med-
ical help immediately.
• Batteries must not be thrown into a fire, short-circuited, taken apart or recharged. Risk of explosion!
• Low batteries should be changed as soon as possible to prevent damage caused by leaking. Never use a combination of old and
new batteries together, nor batteries of different types.
• Wear chemical-resistant protective gloves and safety glasses when handling leaking batteries.
Important information on product safety!
• Do not place your device near extreme temperatures, vibrations or shocks.
• Protect it from moisture.
5. Elements
A: Display (Fig. 1):
A 1: Calendar week
A 3: Calendar (actual day in brackets)
A 5: Time with seconds
A 7: Moon phase
B: Buttons (front) (Fig. 1):
B 1: ▲ button
B 3: HOME button
B: Buttons (back) (Fig. 2):
B 4: ALARM ON/OFF switch
14
Seite 8
A 2: Day of the week
A 4: Date
A 6: DST and DCF symbols, optionally alarm / snooze symbol
A 8: Indoor temperature
B 2: ▼ button
B 5: RESET button
Radio-controlled alarm clock with monthly calendar
B 6: MODE button B 7: + / 12/24 button
B 8: - /°C/°F button B 9: SNOOZE/LIGHT button
C: Housing (Fig. 2):
C 1: Battery compartment C 2: Stand
6. Getting started

6.1 Insert the batteries

• Open the battery compartment and insert the two batteries 1,5 V AA, polarity as illustrated.
• Close the battery compartment again.
• The device will alert you with a beep and all LCD segments will be displayed for a short moment.
• On the display appears the indoor temperature.
6.2 Reception of the DCF frequency signal
• The clock will now scan the DCF frequency signal and the DCF symbol will be flashing on the display.
• During the reception a button operation is not possible.
• When the time code is received successfully after 2-12 minutes, the radio-controlled time, the DCF symbol, the moon phase and the
actual calendar day are displayed steadily in the display.
• You can start the initialization manually.
• Press and hold the -/°C/°F and +/12/24 button at the same time for three seconds.
• The DCF symbol will be flashing.
• Interrupt the reception by pressing again the button +/12/24 and the button -/°C/°F at the same time for three seconds.
• The DCF symbol disappears.
• The DCF reception always takes place daily at 3:00 o'clock in the morning. If the reception is not successfully received at 3:00
o'clock in the morning, the DCF symbol disappears. The next receive operation is again at 4:00, 5:00 or 6:00 o'clock in the morning.
• There are three different reception symbols:
flashing – reception is active
stays – reception is very good
No symbol – no reception / time is manually set
15