Insert The Batteries - TFA Dostmann MINI CHARGE Instrucciones De Uso

TFA_No. 60.2020_Anleitung 17.10.2017 10:13 Uhr
MINI CHARGE – Digital alarm clock with USB charging function
5. Elements
A: Display (Fig. 1):
A 1: Alarm symbol A 2:
A 3: Time/alarm time A 4:
A 5: Date and weekday A 6:
A 7: Indoor temperature and humidity
B: Buttons (Fig. 2):
B 1: + button B 2:
B 3: ALARM button B 4:
B 5: SET button B 6:
C: Housing (Fig. 1+2):
C 1: USB Port 1 (1 Amps) C 2:
C 3: Battery compartment C 4:
6. Getting started
• Remove the protective film from the display.
• Connect the attached power adapter to the alarm clock. Insert the power adapter pin into the device jack and connect the plug to a wall socket.
Important! Make sure that your household voltage is no more than 240V! Otherwise your device may be damaged.
• The device will alert you with a beep and all segments will be displayed for a short moment.
• The indoor temperature and humidity appear on the display.

6.1 Insert the batteries

• The batteries will operate as a backup power source in case of power failure.
• For a permanent backlight, to use the charging function and to conserve battery power, use the supplied power adapter.
• Open the battery compartment at the back.
• Insert three new AAA 1,5 V batteries into the battery compartment. Make sure the polarity is correct.
• Close the battery compartment again.
14
Seite 8
AM/PM
Battery symbol
Loading status port 1+2
– button
NAP button
LIGHT/SNOOZE button
USB Port 2 (2 Amps)
Power adapter jack
MINI CHARGE – Digital alarm clock with USB charging function
6.2 Backlight
• Attention: Continuous illuminated backlight only works when using the power adapter.
• Press the LIGHT/SNOOZE button once to dim the backlight.
• Press the LIGHT/SNOOZE button once more to turn off the backlight.
• To temporarily activate the backlight, press the LIGHT/SNOOZE button (in battery operation only).
7. Operation
• The device will automatically quit the setting mode if no button is pressed for a few seconds.
• Press the LIGHT/SNOOZE button in setting mode to return to normal mode.
• Press and hold the + or – button in setting mode for fast mode.
7.1 Settings
• Press and hold the SET button in normal mode for three seconds to enter the setting mode.
• ENGLISH (default) flashes on the display.
• Press the + or – button to choose the language: English - ENGLISH, German - GERMAN or Spanish - ESPANOL.
• If you select English, the display will now appear in English.
• Press the SET button again to do the settings in the following sequence: the button tone (BEEP ON - default), the hours, the minutes, the
year, the month and the day, the temperature unit (°C - default) and the snooze interval (10 minutes - default). Press the + or – button to
adjust it.
• Confirm the setting with the SET button.
7.1.1 Snooze function setting
• In the setting mode you can set the snooze interval.
• Press the + or – button to set the desired time duration in steps of 5 minutes (5 to 120 minutes).
7.1.2 24- or 12-hour system setting
• Press the + button in normal mode to choose the 12 HR or 24 HR system.
• In the 12-HR system AM (before noon) or PM (after noon) appears on the display.
15