Diamond Blades; Maintenance - QEP 83200Q Instrucciones De Funcionamiento

fIgurE 16
C . Use the hexagonal wrench to hold the
blade nut and use the spanner wrench
provided to hold the shaft . Loosen the nut
turning clockwise as in (Fig 17) .
D . Ensure that the shaft and flanges are
clean . Mount blade back on to shaft
ensuring that the directional arrow on the
blade is rotating towards the material to
be cut .
E . Insert flange and lock nut . Tighten
counterclockwise .
fIgurE 17

MAINTENANCE

ALWAYS DISCONNECT THE TOOL FROM
THE POWER SOURCE BEFORE CLEANING OR
PERFORMING ANY MAINTENANCE
TO AVOID ACCIDENTS,
Please do not try to service this machine on
your own .
Avoid using solvents when cleaning plastic
parts . Most plastics are susceptible to damage
from various types of commercial solvents and
may be damaged by their use . Use clean cloths
to remove dirt, carbon dust, etc .
LET BRAkE FLUIDS, GASOLINE, PETROLEUM-
BASED PRODUCTS, PENETRATING OILS, ETC.
COME IN CONTACT WITH PLASTIC PARTS.
THEY CONTAIN CHEMICALS THAT CAN
DAMAGE, WEAkEN OR DESTROY PLASTIC.
1 . ALWAyS clean the tile saw after each use
and store it in a dry location .
2 . ALWAyS wipe off all exterior surfaces and
keep the cutting table clean and free of
all debris .
3 . ALWAyS check the blade for cracks or
damage BEFORE each use .
4 . ALWAyS store the cord in the compartment
underneath the saw after each use .

diamOnd BLadeS

• Use only 8 in. (203 mm) continuous rim
diamond blades with a 5/8" arbor opening in
this saw . Failure to do so may result in severe
bodily injury and damage to the saw .
• The diamond blade that comes with this saw
will cut ceramic, porcelain and marble tile .
Due to the hardness of some porcelain, slate
and stone, purchasing a blade specifically
designed to cut these hard tiles, will speed up
the cutting time required . IMPORTANT: Always
let the blade cut at its own speed, moving the
material slowly into the blade . Do not force the
material being cut .
diamOnd BLade dO'S & dOn'tS
1 . DO inspect blades daily for cracks or
uneven wear . Discard cracked, chipped or
bent blades!
2 . DO use manufacturer's recommendation
for matching the right blade with the right
material being cut .
3 . DO inspect the arbor shaft for uneven wear
before mounting the blade .
4 . DO use blades with the correct arbor size on
a compatible arbor shaft .
– 9 –
DO NOT AT ANY TIME