Installation Procedure; Important - Toto Aimes TS626F2 Manual De Instrucciones Y Del Propietario

1) Plumb a 1/2" NPT male nipple (not
included) extending between 3/8"
(9.5mm) and 7/8" (16mm) beyond the
finished wall surface. Wrap the threads
of the nipple with pipe tape.
N OTE: The hole for the nipple should
not be larger than 1" (25mm) in
diameter.
2) Remove the two mounting bolts
from the bottom of the hand-
shower bracket, then remove
the mounting bracket and
adapter.
3) Tighten the adapter onto the nipple,
taking care not to damage the o-ring,
then install the plastic cover over the
adapter.
Place the mounting bracket against
the wall and mark the location of the
mounting holes. Remove the mount-
ing bracket, drill holes in the marked
locations, and install the included wall
anchors.
IM PORTANT: Be sure to install in the
order indicated.
4) Secure the mounting bracket to the
wall anchors with the included screws.

INSTALLATION PROCEDURE

Handshower
Bracket
4
1/2" NPT
Male Nipple
3/8"
(9.5mm) -
7/8"
(16mm)
Mounting
Bracket
Mounting
Bolts
2
3
Screws
Finished
Wall
Surface
Adapter
1
Nipple
Plastic
Cover