Rear Panel Features - Vox VR15 Manual De Usuario

REAR PANEL FEATURES

12 – FOOTSWITCH JACK
Connect the optional VF-001 Footswitch to this jack.
13 – HEADPHONE JACK
A pair of stereo headphones, between 8 & 600 ohms
impedance, can be connected to your VR15 for "silent"
practise. Inserting the headphone plug into this socket
automatically disconnects the power amplifier from both
the internal loudspeaker, and the external loudspeaker
jack.
Although great care has been taken in designing your
VR15 to sound as good as it can into headphones, it
must be remembered that headphones are not guitar
loudspeakers (they have a very special frequency re-
sponse), and with the many different brands of head-
phones on the market, the sound quality of the VR15
into headphones may not be as good as it is into its own
speaker system.
14 – EXTERNAL LOUDSPEAKER JACK
An external loudspeaker system can be connected to your
amplifier by using this socket.
This socket disconnects the amplifier from the internal
loudspeaker. Any guitar loudspeaker cabinet can be used
provided that the impedance is between 8 and 16 ohms.
WARNING! To ensure that your system works cor-
rectly, you must observe the following points.
a) Don't use an external speaker whose impedance
is other than 8 ohms.
Twin channel, guitar amplifier with 8 inch custom made
loudspeaker.
15 watts RMS power output utilising VOX proprietary
Valve Reactor power amplifier technology with built-in
12AX7/ECC83 tube (valve).
• Dimensions (W x H x D): 390 x 358 x 190 mm
• Weight: 8 kg (17.64 pounds)
• Output Power: 15 Watts RMS into 8 Ohms
• Speaker: Vox (8", 8 Ohm)
• Inputs: Input jack, Footswitch jack
• Outputs: External LoudSpeaker jack, Headphone jack
• Options: VF-001 Footswitch
*Specifications are subject to change without notice.
©2004 VOX AMPLIFICATION LTD.
15
SPECIFICATIONS
(15.35 x 14.09 x 7.48 inches)
14
b) Don't connect a speaker whose rated input capac-
ity is less than 15 watts. The speaker may be destroyed
if you ignore this caution — not recommended!
c) You must use a speaker cable to connect an exter-
nal speaker. Don't use a shielded cable like the one
you use to connect a guitar to an amp.
d) You must turn off the power before connecting the
cable. Connecting the cable while the power is turned
on may damage your amp.
We think you will be very pleasantly surprised at how
good this amplifier will perform when connected to a
4x12" speaker cabinet!
15 – MAINS POWER CONNECTOR/FUSE
The mains power required by your amplifier is connected
using this device.
Warning! Use only the power cord supplied with your
amplifier, or a replacement of the exact same specifi-
cation.
Warning! Only connect this amplifier to a suitable
mains power supply that matches the rating indicated
on the back panel of your VR15 amplifier. IF IN ANY
DOUBT CONTACT YOUR DEALER!
16 – AIR VENTS
In no circumstances must these air vents be covered in
any way that prevents cooling air to circulate.
IMPORTANT REMINDER: Your VR15 should only be
"examined"/repaired by an Authorized Vox Service
Centre. Failure to do so will void your warranty.
13 12 16