Rear Panel - Vox MINI5 Rhythm Manual De Usuario

11. EFFECTS knob 2
This knob enables you to select a delay/reverb-type effect and set the
intensity of the effect. To bypass the effects, rotate the knob all the
way to the left.
To apply an effect (selected via this knob) to the microphone input,
use the SEND knob to set the intensity of the effect.
To turn off the delay/reverb effect applied to the guitar input, set the
knob to the minimum position of the "swoosh" of the corresponding
effect type.
12. TAP button, LED
This button enables you to set the time of the Delay and Reverb ef-
fects. Tap this button twice to set the time. The duration between two
taps will be used as the time value. The TAP LED will flash in sync
with the time.
HINT: To set the time to exactly match the tempo of a song, press the
TAP button several times along with the song.
RHYTHM Section
13. TEMPO knob
This knob controls the tempo of the rhythm pattern.
14. GENRE selector
This enables you to select the genre for a rhythm pattern.
15. LEVEL knob
This knob controls the volume level of the rhythm pattern.
16. VARIATIONS button, LED
This is where you can select one of nine variations for each genre.
(see p. 7 "Using the Rhythm Section")
To enable the tuner function, press and hold down the VARIATIONS
button for more than one second. (see p. 8 "Using the Tuner")
17. START/STOP button
This button starts or stops playback of the rhythm pattern.
6
Power/AUX IN/PHONES Section
18. Power button, LED
Pressing and holding down this button enables you to turn the power
on or off. The power LED will light up when the power is turned on.
19. AUX IN jack
Connect an external audio device to this jack. This enables you to
conveniently connect an audio player and play your guitar along with
the player's output.
20. PHONES jack
Use this jack if you're plugging directly in to a mixer, recording de-
vice, or if you're using headphones. The output signal from this jack
is taken before the power amp, and the character of the guitar amp
cabinet is applied to it.
NOTE: Connecting headphones to this jack will mute the internal speaker.
NOTE: Be sure to make a stereo connection at the PHONES jack.

Rear Panel

1
1. DC 12V jack
Connect this jack to the included AC adapter.
NOTE: The AC adapter should only be used with the main unit. Do not
use the adapter with other devices since doing so may cause a
malfunction.