Toto WT173M Manual De Instrucciones Y Del Propietrario página 13

Installing Toilet on the In-Wall Tank System
1) Apply lubricant using the supplied sponge on the inlet and
outlet drain to facilitate installation. Insert the inlet pipe into
the tank drain outlet until it stops.
Place the edge of a ruler against the fi nished wall and
on top of the inlet pipe. Mark the location as shown and
remove the inlet pipe.
Repeat this process with the fl ange pipe.
2) Insert the inlet pipe end with the gasket into the back of the
toilet bowl.
Place the edge of a ruler against the whole width of the back
of the toilet and on top of the inlet pipe. Mark the location as
shown and remove the inlet pipe.
Repeat this process with the flange pipe.
3) As shown in the figure, measure the distance between
two lines "a" and "b". From that dimension, mark the
cutting line by measuring from the edge opposite from
the gasket and saw off the excess.
Repeat this process for the flange pipe.
4) Bevel the cutting edges as shown.
Screw the threaded mounting studs onto
the tank and leave 2-1/8"(54mm) exposed.
5) Insert the inlet pipe and the flange pipe into the
appropriate drain holes.
6) Toilet bowl type
7)
The parts on the right are used for installing
toilet bowl. Please see the installation manual of
toilet bowl.
Proceed to step 7.
13
Inlet Pipe
a
a + 1/8"
(3mm)
Install according to the Installation Guide
enclosed with the toilet bowl.
Nut (2)
Stud bolt Flange (2)
Mark
Flange
Pipe
Mark
Mark
b
b + 1/8"
(3mm)
Washer (2)
Cap (2)