auna Connect 100 Manual Del Usuario página 58

EN
58
Wireless network (WPS PBC):
If you use a router with WPS/QSS button, you can easily connect to
the network using the WPS function. Open the WPS function and press
the WPS/QSS button on the router within 120 seconds. The connection
between the router and your device will then be established automatically.
Manual configuration:
You can select DHCP (the IP is automatically assigned) or manually enter the
IP address for the wireless connection. If you selected manual entry for the
wireless connection, you must make the following entries:
1. SSID (name of the access point)
2. IP address
3. Subnet mask
4. Default gateway
5. Preferred DNS server
Alternate DNS server:
You can select a specific network if more than one network connection is
available in your area.
Activate/deactivate the WLAN network:
• When you enable the wireless network, the device automatically
searches for the available AP. Select the required AP. Enter the WEP or
WPA password to connect to the wireless network.
• If the wireless network is not available or the connection could not
be established, the icon in the upper right corner is crossed out with a
cross.