Introduction; Main Features; Technical Specifications - PRASTEL UNIK2E Manual Técnico De Instalación

UNIK2E
V2

1. INTRODUCTION

The universal self-learning UNIK2E control unit has been designed for the automation of an access with 1 or 2
12VDC (24VDC)* motors with or without limit switches. Its innovative self-learning procedure makes for
quick and easy installation and its three trimmers permit fine adjustment of all main parameters: force
(or speed), pause time, obstacle detection sensitivity and closing delay between the two leaves of the
gate when two motors are used.
The following are available:
- simplified programming, thanks to which the unit automatically performs a learning operation to acquire
running time and determine slow-down setting at ninety percent of opening and closing runs;
- A professional programming in which the installer can determine the instant in which the gate starts to
slow-down, the enabling of the pedestrian opening via radio, the safety device trigger mode.

2. MAIN FEATURES

•
Management and control of 12 VDC (or 24 VDC)* powered, 1 or 2 motor-driven automated accesses
•
Motors closing offset adjustable from 0 to 15 seconds using trimmers
•
Double limit switch input open close
•
Motor force (speed) adjustable from 50-100%.using a trimmer.
•
Customisable partial opening (for pedestrian transit)
•
Softstart (slow motor start)
•
1 to 60" stand-by time adjustment via trimmer.
•
0.1 to 3.0" obstacle detection triggering time adjustment via trimmer.
•
Initial settings using dip-switches
•
Signalling LEDs (8)
•
Expansion for electric lock 12V 15W max (optional board ELU)
•
Expansion for courtesy light 230VAC 500W max (optional board LCU)
•
Built in battery charger with solar panel management
•
Box predisposed for optional 12V 1.2Ah battery for emergency manoeuvres (max connectable battery 7Ah)
•
Built-in 433MHz rolling-code receiver with 180 memorisable codes
•
Flash microprocessor re-programmable on-board via serial interface.
•
Programming and control of the control unit using a portable terminal GTSYSTEM (optional)
•
Built to European reference Directive Standards (R&TTE 99/05/CE)
DECLARATION OF CONFORMITY
Prastel declares that UNIK2E IS IN ACCORDANCE with the 99/05/EC (R&TTE) direcitve
The complete declaration of conformity is available in Prastel or to the internet address

3. TECHNICAL SPECIFICATIONS

Transformer power supply:
Control unit power:
Motor output:
Max current peak of motor:
Accessories power:
Environmental operating temperature
Programming parameters:
BOX IP rating:
(*)When using 24VDC motors, replace the supplied transformer with a 230/20VAC transformer with at least
20VA more power than the motor. The maximum power of the 24VDC motor driven by the control unit is 120W.
Only 12V batteries can be connected to the control unit, so when there is no mains power 24VDC motors will be
powered at 12VDC.
ENGLISH
230VAC
12VAC (20VAC)*
12 VDC max 2 x 50Watt (24VDC max 2 x 60W)*
10 Amperes
12 VDC - 250 mA protected by fuse (see info page 13)
: -20°C / + 55°C
memorised in EEPROM
IP54
3
ISUNIK2Ev2_EU_10_12.doc
www.prastel.com