The probe can be connected to the remote temperature transmitter any time after initial
setup. There is no need to reset the units, should the probe be unplugged or re-plugged
again. The weather station will automatically detect the temperature probe data and will
display the temperature data on channel 2 after the probe is plugged.
INSTALL AND REPLACE BATTERIES IN THE TEMPERATURE TRANSMITTER
INSTALL AND REPLACE BATTERIES IN THE WEATHER STATION
The weather station uses 2 x AA, IEC LR6, 1.5V batteries. To install and replace the
batteries, please follow the steps below:
The temperature transmitter uses 2 x AAA, IEC LR3, 1.5V batteries.
To install and replace the batteries, please follow the steps below:
1.
Remove the battery compartment cover.
2.
Insert the batteries, observing the correct polarity (see marking).
3.
Replace the battery compartment cover.
47