TFA Dostmann DIVA BASE Manual De Instrucciones página 51

Note:
Channel 1 will show the reading from the internal sensor of the dual channel transmitter;
channel 2 will show the reading sensed by the probe. If the probe is not plugged to the
transmitter, " - -" will be shown on channel 2.
5. In order to ensure sufficient 868 MHz transmission, the final position between the
weather station and the temperature transmitter should not be more than 100 meters
(see notes on "Positioning" and "868 MHz reception").
6. Once the remote temperature has been received and displayed on the weather
station, the DCF time code reception is automatically started. This takes typically
between 3-5 minutes in good conditions. If the DCF time not received within 10
minutes, press the SET button to adjust the time manually.
When two temperature transmitters are used
1. Remove all the batteries from the weather station and temperature transmitters and
wait 60 seconds (if setting has been done with one temperature transmitter before).
2. Insert the batteries into the first temperature transmitter.
3. Within 30 seconds of powering up the first temperature transmitter, insert the batteries
into the weather station. Once the batteries are in place, all segments of the LCD will
light up briefly. Then the indoor temperature and the time as 0:00 will be displayed. If
50