Dörr CV-01 Manual De Instrucciones página 9

03 | NOMENCLATURE
›
Dead Kitten
1
2 Microphone
3.5 mm audio jack
3
4 Shock Mount
5 Locking screw
Universal hot shoe
6
6a) ¼ inch tripod mount
04 | USE OF THE CONNECTION CABLES/OPERATION
PLEASE NOTE To ensure proper operation, always use the two supplied connection cables as described below.
ATTENTION Please note that using the microphone increases the battery consumption of your smartphone or camera.
04.1 WITH CAMERA, CAMCORDER OR OTHER AUDIO/VIDEO RECORDING DEVICES
For using the DÖRR CV-01 microphone with a camera, camcorder or other audio/video recording devices, please use the supplied
spiral connection cable (7) with TRS mini-jack plug.
Always plug the TRS angle mini-jack plug (7a) into the audio jack (3) of the microphone. Plug the TRS mini-jack plug (7b) into the micro-
phone jack of your camera or your recording device (please refer to manual of the recording device.
7a › Microphone
NOTE With the
onto a tripod or an audio
is recommended (optionally available in specialized electronic stores).
PAGE 02
¼ inch tripod mount (6a)
boom. For this purpose a longer connection cable with 3.5 mm mini-jack plug
7 Spiral connection cable to camera
7a) TRS angle mini-jack plug 3.5 mm (mono, three-pole)
› to microphone
7b) TRS mini-jack plug 3.5 mm (mono, three-pole)
› to camera
8 Straight connection cable to smartphone
8a) TRRS angle mini-jack plug 3.5 mm (mono, three-pole)
› to microphone
8b) TRRS mini-jack plug 3.5 mm (mono, four-pole)
› to smartphone
underneath the universal hot shoe (6) the microphone
09
7b › Recording device
Slide the universal hot shoe (6) into the
hot shoe mount of your camera/camcorder
and turn the locking screw (5) down until
microphone holds tight on the camera.
Connect your camera/camcorder with the
microphone like described above, using
the spiral connection cable (7). Start the
video recording at your camera/camcor-
der (please refer to manual of the recor-
ding device).
can be mounted