Mixing Solutions And Filling The Solution Tank - Solo AccuPower 416 Manual De Instrucciones

Mixing solutions and filling the solution tank

6. Mixing solutions and filling the solution
tank
When handling the substances for spraying,
always follow the safety instructions printed
at the start of these operating instructions (pay
special attention to section 1.3 "Safe handling of
spray pesticides") and the information provided by
the manufacturer of the particular substance being
sprayed.
Additional general rules for filling the solution tank
Always ensure that the drain valve (18) is
closed before filling any fluids into the
solution tank (the lever should be set at right
angles to the hose).
Markings (4) are applied to the side of the solution
tank (1) to indicate the fill level. The solution tank
has a maximum capacity of 20 litres (top marking).
When filling up with correctly mixed spraying
agent, ensure you do not fill above the top
marking.
The filling strainer (3) in the spraying agent filler
opening has a mesh aperture of 0.55 mm. Always
use the filling strainer when filling the solution tank.
Check the filling strainer before filling the tank. If
the strainer is damaged, replace it with a genuine
replacement part (part no.: 4200104) with the
correct mesh aperture.
When you are filling the tank with spraying agent,
switch the pump off, take the device off your back
and place it on a suitable surface on Never allow
the solution tank to overflow or public bodies of
water, rainwater drains or sewage drains to
become contaminated. Wipe up any spilled
solution immediately.
When filling the tank, always ensure that the hand
valve and the drain valve are closed.
Never mix the spraying agent directly in the
solution tank.
After filling, firmly close the screw cap on the filling
opening to prevent any solution from escaping.
ENGLISH 12
Required volumes of spraying solution
Mix the solutions in accordance with the
instructions provided by the manufacturer of the
spraying agent. Choose the appropriate volume
according to requirements.
The following are guide values for plant protection:
 Plants cultivated at ground level – 0.3-0.5 l per
2
10 m
 Low shrubs – 1.0-1.5 l per 10 m
 Espalier trees, bush trees 0.5-1.0 l per tree
 Larger bush trees 2.0 l per tree
Mixing pesticides
Only mix pesticides out in the open. Never do this
inside living spaces, stables or in storage spaces
that are used for food or animal feed.
Pesticides in powder form:
 Mix the pesticide in a separate container, not in
the solution tank.
 Ensure that the mixture is thoroughly mixed
before pouring it through the filling strainer into
the solution tank.
 Use the spray tube to mix the spraying solution
in the tank again.
Liquid pesticides:
 Fill 1/4 of the solution tank with water.
 Then pre-mix the spraying agent with water in a
separate container according to the instructions
provided by the manufacturer of the spraying
agent.
 Pour the pre-mixed solution through the filling
strainer into the solution tank.
 Top up with the required amount of water in
accordance with the manufacturer's instructions.
 Use the spray tube to mix the spraying solution
in the tank again.
When using spraying agents that have been mixed
from herbal preparations, the liquid will need to be
pre-filtered before pouring it through the filling
strainer, as otherwise the strainer may become
blocked.
2