Radio Reception; Ipod - Yamaha MCR-550 Manual De Instrucciones

TROUBLESHOOTING

Radio reception

Problem
FM stereo reception is
noisy.
The desired station
cannot be tuned into
with the automatic
tuning method.
The preset selecting
function does not
work.
There is distortion,
and clear reception
cannot be obtained
even with a good FM
antenna or an outdoor
antenna.

iPod

Note
In case of a transmission error without a status message appearing in the front panel of this unit, check the connection to your iPod (see
page 9).
Status message
iPod Connecting
iPod Charging
Unknown iPod
iPod
iPod Unplugged
iPod OverCurrent
Problem
No sound.
18
En
Cause
The antenna is connected improperly.
The characteristics of FM stereo
broadcasts may cause this problem
when the transmitter is too far away or
the antenna input is poor.
The signal is too weak.
The preset (memory) may have been
erased.
Multipath reflection or other radio
interference may have occurred.
Cause
This unit is in the middle of recognizing
the connection with your iPod.
There is a problem with the signal path
from your iPod to this unit.
The iPod being used is not supported by
this unit.
The iPod software is out of date.
The play back of the iPod is finished.
For example, all the songs in the
selected album have finished being
played back.
Your iPod was removed from the iPod
dock.
The connected iPod is not playable on
this unit. The iPod is connected at an
angle.
Cause
The power of the unit is off.
The iPod software version has not been
updated.
The iPod is in the process of connecting
with the unit.
Remedy
Check the antenna connections.
Try using a high-quality directional FM antenna.
Switch to monaural mode.
Use a high-quality directional FM antenna.
Use the manual tuning method.
Preset radio stations again.
Change the height, direction, or placement of the
antenna.
Remedy
If the message continues to appear in the front panel
display and playback does not start, connect the iPod
again.
Connect the iPod again.
Only iPod (5th generation), iPod classic, iPod nano,
and iPod touch are supported.
Update the iPod software version to the latest.
Station your iPod back in the iPod dock.
Disconnect the iPod. Change input source other than
iPod and select iPod as input source again. Then
connect playable iPod again.
Remedy
Connect the power cable correctly.
Download the latest iTunes software to update the
iPod software version to the latest.
Please wait for a while.
page
8
—
13
—
13
13
—
page
—
9
—
—
9
9
page
—
—
—