Cleaning And Care - Clatronic MC 3020 Instrucciones De Servicio

Moldeador eléctrico
Ocultar thumbs Ver también para MC 3020:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 17
Hair Smoother/Hair Crimper:
If you would like to turn the plates, open the device and pull the plates out:
Fine-toothed accessories: to make small waves in hair
Flat accessories:
Insert the required plates into the guide mechanism until they lock in place.
Always use two similar plates.
Use the hair smoother/hair crimper only for dry hair. Take a strand of hair
and pull it carefully downwards until it is taut. The remaining hair should be
put up or fi xed in place. Before the halves are pressed together for approx.
5 seconds, we recommend that you ensure that the hair is positioned
correctly. Always begin at the base of the hair and move the device in the
direction of the hair tip. In order to produce a uniform appearance it is im-
portant that the next strands fall in one line. In order that the waves remain
in your hair for a longer time, we recommend that you use either a coarse
comb or only your fi ngers.
7. Allow the device to cool down before turning the plates! Push the plates into
the guide mechanism only two at a time (2 x fi ne waves or 2 x smooth) as
otherwise the hair may be damaged!
8. Switching off
Switch the device off after use by pushing the on/off switch downwards and
removing the mains plug. The green control lamp goes off. Leave it cool for a
few minutes before putting it away.
In order to obtain a strong „frizzle effect" with the hair crimper you should apply
gel or hairspray before use (it is possible that the hair will „steam" somewhat, but
GB
this is normal). For a loose „permanent wave look" please use thick strands, crimp
them with the device for one second and then shake your hair over your head to
the front and then to the back again. We do not recommend using the device if
your hair is damaged or bleached.
Remove the plug from the socket before cleaning the device.
Clean the housing with a soft, dry cloth without additives.
The round brush can be cleaned with a suitable object (comb or brush).
If necessary you can use a commercial dish washing detergent.
The curling tongs can be cleaned with a slightly damp cloth.
Dry the attachments and the device thoroughly after you have cleaned them.
The device must never be immersed in water!
38
05-MC 3020 38
for smooth hair
Styling Tips

Cleaning and care

15.02.2006, 10:17:23 Uhr

Publicidad

Tabla de contenido
loading

Tabla de contenido