Note - Enraf Nonius Crosswalker Instrucciones De Manejo

Ocultar thumbs Ver también para Crosswalker:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

The Crosswalker is a specialised device for blood circulation and ergometer training! Inexpert use
can damage the Crosswalker.
The patient shall receive instructions for correct operation of the Crosswalker.
Using the Crosswalker in a manner other than that described in these Instructions can lead to
hazardous situations. You are advised to read through these Instructions carefully before starting
to use the Crosswalker.
If the power cord gets damaged, remove the power cord from the socket to prevent injury.
If general faults, fluctuations in resistance or faults in the control panel occur then stop the
training immediately and switch off the device.
Keep unsupervised children away from the training equipment at all times.
The user must assume a correct biomechanical position.
Training incorrectly can lead to injury. Supervision by an expert (para)medic is therefore
essential.
The Crosswalker shall not be used for diagnostic purposes
The apparatus may not be used in so-called "wet rooms" (hydrotherapy rooms)
The apparatus should only be used by patient within the permissible weight range as indicated in
the technical specifications
The heartrate monitoring system with earclip or hand/wrist measurement is only intended for
heartrate measurement. For heartrate targeted training only the Polar® system with chestbelt is
allowed
A daily pre-use check shall be carried out on:
the heart rate measuring sensors
o
the moving parts
o
In case of a dermatological condition, injured skin shall never contact the keyboard, heart-rate
sensor, ear sensor, hand sensor, saddle, handlebar or pedals.
Note: all parts that come in contact with the patients should be cleaned and disinfected (EEC No.
603-000-00-5).
3.2.3

Note:

If any faults should arise in your Crosswalker, please contact your equipment supplier or Enraf-
Nonius B.V. (The Netherlands.) Any repairs and installations should only be performed by a
service technician who has been authorised by Enraf-Nonius.
Repairs performed by service technicians who are not authorised by Enraf-Nonius and/or the use
of non-original (replacement) parts and/or auxiliary equipment invalidates the warranty and can
be hazardous.
An annual service check is necessary. Technical maintenance shall only be done by personnel,
authorized by Enraf-Nonius. A maintenance checklist is available in the service manual.
29

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Cruiser

Tabla de contenido