Using The Crosswalker With En-Track Software; General; Possibilities With En-Track - Enraf Nonius Crosswalker Instrucciones De Manejo

12 Using the Crosswalker with EN-Track software

12.1 General

The Crosswalker is an addition to the existing range of EN-Strength exercise machines. This part of the
documentation describes the use of the Crosswalker with the EN-Track System, and gives some
examples to make it easier to understand. To use the Crosswalker with the Track System you need to
have a mastery of the EN-Track software, because controlling the Crosswalker is very similar to
controlling the EN-Strength exercise machines. If you are unsure, consult the software help for EN-Track
or the EN-Track software manual.
12.2

Possibilities with EN-Track

Using EN-Track enables you to execute more profiles on the Crosswalker. The number of profiles
corresponds to the number of profiles you can create with the EN-Track system.
The Crosswalker can be used in an exercise profile in a random sequence, just like the EN-Strength, EN-
Free and EN-TreeP equipment.
To create a controlled training, you can select from a multiplicity of manually created training profiles. You
can enter these on the chip-card via just a few actions.
To create an exercise in the EN-Track software, select the tab EN-Cardio/Crosswalker exercises. For
further explanation, please refer to the EN-Track software manual.
6
7
8
9
1
Fig. 16 Chipcard-controlled training
6
7
8
9
1
Fig. 17 Display of an EN-Track training session
3 2
3 2
To start the training session, insert the
chip-card into the Crosswalker.
10
The exercise information will then
appear on the control panel.
Press the green start switch (1) or
start walking to accept the exercise.
4
5
The training time and the resistance in
W or Nm will be displayed per series.
10
If you are training for heart rate (bpm),
the desired heart rate will appear.
4
5
41