Specific Safety Rules - Makita DF030D Manual De Instrucciones

ENGLISH
1. Button
2. Battery cartridge
3. Switch trigger
4. Lamp
SPECIFICATIONS
Capacities
No load speed (min
Chuck capcity
Overall length
Rated voltage
• Due to our continuing programme of research and development, the specifications herein are subject to change without
notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
............. Read instruction manual.
Intended use
The tool is intended for drilling and screw driving in wood,
metal and plastic.

SPECIFIC SAFETY RULES

DO NOT let comfort or familiarity with product (gained
from repeated use) replace strict adherence to drill
safety rules. If you use this power tool unsafely or
incorrectly, you can suffer serious personal injury.
1. Hold power tools by insulated gripping surfaces
when performing an operation where the cutting
tool may contact hidden wiring or its own cord.
Contact with a "live" wire will make exposed metal
parts of the tool "live" and shock the operator.
2. Always be sure you have a firm footing. Be sure
no one is below when using the tool in high
locations.
3. Hold the tool firmly.
4. Keep hands away from rotating parts.
5. Do not leave the tool running. Operate the tool
only when hand-held.
6. Do not touch the drill bit or the workpiece
immediately after operation; they may be
extremely hot and could burn your skin.
7. Some material contains chemicals which may be
toxic. Take caution to prevent dust inhalation and
skin contact. Follow material supplier safety data.
4
Explanation of general view
5. Reversing switch lever
6. Speed change lever
7. Adjusting ring
8. Graduation
Model
Steel
Wood
Wood screw
Machine screw
High (2)
-1
)
Low (1)
Net weight
SAVE THESE INSTRUCTIONS.
END004-2
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
IMPORTANT SAFETY
ENE034-1
INSTRUCTIONS
FOR BATTERY CARTRIDGE
GEB002-2
1. Before using battery cartridge, read all
instructions and cautionary markings on (1)
battery charger, (2) battery, and (3) product using
battery.
2. Do not disassemble battery cartridge.
3. If operating time has become excessively shorter,
stop operating immediately. It may result in a risk
of overheating, possible burns and even an
explosion.
4. If electrolyte gets into your eyes, rinse them out
with clear water and seek medical attention right
away. It may result in loss of your eyesight.
5. Do not short the battery cartridge:
(1) Do not touch the terminals with any
conductive material.
(2) Avoid storing battery cartridge in a container
with other metal objects such as nails, coins,
etc.
(3) Do not expose battery cartridge to water or
rain. A battery short can cause a large current
flow, overheating, possible burns and even a
breakdown.
9. Pointer
10. Bit
11. Sleeve
12. Bit-piece
DF030D
10 mm
21 mm
5.1 mm x 63 mm
M6
0 - 1,300
0 - 350
6.35 mm
157 mm
0.88 kg
D.C. 10.8 V
ENC007-2