Fitting/Changing Batteries - BOLERO CF129 Manual De Instrucciones

Installation - Hints for mounting to wall or to the floor
Note:
• Ensure the mounting substrate is suitable and can support the weight of the
safe.
• There are 2 holes at back / 4 holes at bottom to attach the safe to a wall/
floor.
1. Mark the position for 2 holes on the wall or 4 holes on the floor.
2. Drill holes at the marked positions. Each hole should have a diameter of 10mm and a depth of 40mm.
3. Insert 1 sleeve plug with bolt into each hole in the wall or on the floor.
4. Hold the safe to the wall or on the floor so that the thread ends of the bolts protrude through the
openings on the back or the floor of the safe into the interior of the safe.
5. First place the washer and then the small spring washer over the protruding thread ends of each bolt.
6. Finally place the nut onto the end of each bolt and turn it with spanner until the safe is fixed tightly
to the wall or to the floor and cannot be moved.
• Remark: Fixings not suitable for Partition walls.

Fitting/Changing Batteries

• Open the safe door using the key.
• Remove battery compartment cover by
pressing the catch and lifting, then fit batteries
and replace cover.
• Store the keys and instructions in a safe place.
Operation
Set a user personal code
With the safe door open, the word "Opened" will
be displayed.
1. Press '*' and enter a code of between 3 and 6
numerals
2. Press "#" and the Safe Door will lock.
3. The word "Closed" will appear.
To open the safe:
1. Enter the personal code.
2. The word "OPENED" will be displayed and the
safe door will open.
CF129_ML_A5_v4_20190927.indb 3
Head of bolt
Safe
Large washer
To close the safe:
1. When the word "OPENED" is displayed, press
"#"
2. When the display is blank, enter your personal
code.
Note:
•
•
Sleeve plug
Nut
Bolt
Small washer
If an incorrect code is
entered in error the display
will show "E-CODE", press
"*" to cancel.
If an incorrect code is
entered three times, the
display will show "HOLD-5"
and will lock the keypad for
5 minutes. After five minutes
the correct code can be
entered to open or lock the
door.
2019/9/27 16:14
UK
3