hafele 271.91.114 Instrucciones De Montaje página 17

GB
5
Fig. 9
7
7
6
Fig. 10
Lath
Centre support
271.87.101
Installing bed frame
Danger of injury from extending bed frame!
Before opening, make sure that there are no persons, animals or
objects in the area of extension.
3
1
2
• Position the bed frame in the cabinet so that the tips of the bearing plates
4 lie on the bolts of the retainer brackets 3.
• Swing the bed frame upwards into the cabinet in order to bring the
bearing plates into the right position.
• Screw the bearing plates onto the side walls from outside using 4
countersunk-head screws 5 M8 x 30 mm, see Fig. 9
• With double beds the centre support must be screwed to the lower base
with 6 countersunk-head screws M10 x 40 mm, see Fig. 11.
A minimum gap of 6 mm must be maintained between both beds.
4
• Each of the two bearing plates 4 is screwed to the centre support with 3
hexagon-head bolts 6 M6 x 25 mm and hexagonal nuts M6, as well as
with 2 hexagon-head bolts 7 M8 x 10 mm, see Fig. 10.
1
19 mm
2
150 mm
20 mm
90 mm
4
• Insert the two mattress retainers 1 into the bed
frame and secure with nut cap and washer 2,
see Fig. 8.
Fig. 11
6 mm
3
60 mm
40 mm
240 mm
- 17 -
Assembly instructions
Fig. 8
1 Mattress retainer
2 Cap nut M8 with washer
3 Retainer bracket
4 Bearing plate
• This gives rise to high pneumatic-
spring forces on the lower base...
4
...for this reason the lower base has
to be reinforced with a lath,
see Fig. 11.