General Settings; Alarm Function; Audio Settings - OK. OWR 300-B Manual De Instrucciones

eN
Displaying station information
Select a FM station. During FM radio playback press INFO repeatedly to display the following
information (if available):
1. Frequency
2. Audio status (Mono/Stereo)
3. Radio text
4. Program type
5. Signal strength
6. Time and date
AUX-IN
14 This radio allows you to listen to external audio devices.
1. Connect a cable (not included) to the AUX IN-jack (3.5 mm) at the back of the radio.
2. Start playback from the device.
Note
Once an audio cable has been connected to the AUX socket FM or DAB radio are muted. However,
the display will still show the selected radio station. AUX-IN source must be Stereo signal, if AUX-IN
source is Mono signal the unit will be muted.
Attention!
Before connecting an external playback device, carefully read the respective user guide and safety
instructions as well as instructions concerning usage with other devices.

GENERAL SETTINGS

Set date and time
Date and time cannot be set manually, but will be set or updated automatically once a DAB radio signal
is received.

Alarm function

15 Activate and deactivate alarm
The alarm can be set only if the FM or DAB radio are off (Standby):
1. Press INFO/AL. SET button and status ON or OFF and the alarm time are shown in display.
Note: If no settings done within 4 seconds the display will turn off into standby.
2. Press TUNE+/– button to activate (ON) or deactivate (OFF) alarm.
3. Press ENTER button. The hours are flashing and can be set by pushing TUNE+/– button. Press
ENTER button again. Now the minutes are flashing and can be set by pressing TUNE+/– button.
4. Press ENTER button again. The alarm sound – BEEP Tone 1, BEEP Tone 2, DAB- or FM Radio – can
be set with TUNE+/– button.
Stop alarm
1. Snooze function: Press SNOOZE button to suspend alarm sound for a few minutes. The alarm will start
again after 9 minutes.
2. Press STANDBY button to stop/cancel alarm.

Audio settings

In FM radio mode you can chose between mono and stereo mode. Please consider that the radio only
has one loudspeaker which makes stereo playback impossible.
1. During FM radio mode press ENTER button. The display will show the audio mode.
2. Press ENTER button again to switch between Auto- and Mono mode
Automatic power off
The radio will switch off after 15 minutes if it does not receive any FM or DAB radio signal and there is no
playback by an external audio player (AUX). The display light will turn off and current time will be shown
in display.
IM_OWR300-B_150129_V03_HR.indb 22
22
30/1/15 10:52 AM