Troy-Bilt 020210 Manual Del Usuario página 14

SPECmFmCATmONS
Outlet Pressure ......................... 3700 psi
Fmow Rate .............. 4.0 gaMMonsper minute (gpm)
Detergent Use detergent approved for pressure washers
Water
Supply
................ Not to Exceed H00°F
Automatic Cool ............. Wiil cycie when water
Down System reaches i 25 °=i 55°F
Shipping Weight .......................... i SS ibs.
GENERAL HAmNTENANCE
RECOHHENDATmONS
The pressure washer warranty does not cover items that
have been subjected to operator abuse or negiigence.To
receive fuHH vaHue from the warranty, the operator must
maintain the pressure washer as instructed in this manual
NOTE: Shouid you have questions about repiacing
components on your TroyoBiit pressure washer, piease caii
I =888=611 =6708 for assistance.
o Some adjustments will[ need to be made periodicaliy to
properiy maintain your pressure washer.
o AHHmaintenance in this manuai and the engine operator's
manuai shouid be made at ieast once each season.
o If equipped with inflatabie tires_ keep the air pressure at
the value marked on the tire or within i 5 and 40 psi.
Before Each Use
I. Check engine oil level
2. Check water inlet screen for damage.
3. Check inoline fiiter for damage.
4. Check high pressure hose for ieaks.
S. Check detergent siphoning tube and filter for damage.
6. Ched< spray gun_ nozzle extension_ and spray tips for
leaks.
7. Rinse out garden hose to flush out debris.
PRESSURE WASHER
MAINTENANCE
Check and Clean Inlet Screen
Examine the screen on the water inlet. Clean it if the
screen is dogged or replace it if screen is damaged.
_h Pressure Hose
The high pressure hose can develop leaks from wear,
kinking, or abuse. Inspect the hose each time before using
it. Check for cuts_ leaks_ abrasions or bulging of cover,
damage or movement of couplings. If any of these
conditions exist, replace the hose immediately.
WARNING
NEVER repair high pressure hose, RepIace it.
Replacement hose rating MUST exceed maximum pressure
rating of unit,
_ent Siphoning
Tube
Examine the fiker on the detergent tube and dean if
dogged.The tube should fit tighdy on the barbed fitting.
Examine the tube for leaks or tears. Replace the filter or
tube if either is damaged.
Check Gun
and
Nozzle Extension
Examine the hose connection to the spray gun and make
sure it is secure.Test the
trigger by pressing
it and
making
sure it springs back into place when you release it. Put the
safety latch in the on position and test the trigger.You
should not be able to press the trigger.