Pressure Washer Location; How To Start En Ine - Troy-Bilt 020210 Manual Del Usuario

Operation
HOWTO USE PRESSURE
[f you have any problems operating your pressure washen
please call the pressure washer heIpline at 1-888-611-6788.
Pressure Washer Location
Pressure Washer Clearance
waRNING l
Keep at least 5 ff_ (152 cm) clearance on all sides of pressure
washer including overhea&
Place pressure washer outdoors. DO NOT place pressure
washer where exhaust gas could accumulate and enter
inside or be drawn into a potentially occupied building.
Ensure exhaust gas is kept away from any windows_ doors_
ventilation intakes or other openings that can allow exhaust
gas to collect in a confined area (Figure 7). Prevailing winds
and air currents should be taken into consideration when
positioning pressure washer.
| WARNING
Operate pressure washer ONLY outdoors.
Keep exhaust gas from entering a confined area through
windows, doors_ ventilation intakes or other openings.
DO NC)T operate pressure washer" inside any building or
encJosure_ even if doors or windows are open.
/
/
/
/
Typical Pressu_ e
Washe_ Shown
Exhaust Port
How to Start En ine
The best way to start your pressure washer for the first
time is to follow these instructions step-by-steFThis
starting information also applies if you have let the unit sit
idle for at least a day.
I. Place pressure washer near an outside water source
capable of supplying water at a flow rate greater than
5.0 gallons per minute and no less than 20 PSI at
pressure washer end of garden hose.
2. Hake sure unit is in a level position.
3. Check that high pressure hose is connected to spray
gun and pump. See "Preparing Pressure 'Washer for
Use" for illustrations.
4. Connect garden hose to water inlet on pressure
washer pump.
5. Turn ON water, point gun in a safe direction and
squeeze trigger to purge pump system of air and
Damage to equipment resulting from failure to follow this
instruction will void warranty.
6. Attach nozzle extension to spray gun (Figure 8).
Tighten by hand.
7. Choose spray tip you want to use and insert it into
nozzle extension. See
"How
to Use SprayTips'.
8. Engage trigger lock on spray gun trigger (Figure 9).
Trigger Lock