Troy-Bilt 020210 Manual Del Usuario página 4

Section 1: Safety Rules
WARNING
ALWAYS point gun in safe direction and squeeze spray gun
tri_er_ to release pressure and avoid kickback each time,
before starting engine. Engage trigger Ioc!< when not in use.
When starting engine, pull cord slow, iy until resistance is felt
and then pull rapidly to avoid kickback.
After each starting attempt, where engine fails to run, always
point gun in safe direction and squeeze spray gun trigger to
release high pressure.
Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury when gun kicks back.
WARNING
DO NOT touch hot surfaces and avoid hot exhaust gases.
Allow equipment to cool before touching.
Keep at least 5 R. (] 52 cm) clearance on all sides of pressure
washer including overhead.
Code of Federal Regulation (CFR) Tide 36 Parks, Forests, and
Public Property require equipment powered by an internal
combustion engine to have a spark arrester, maintained in
effective working order, complying to USDA Forest service
standard SIOB-IC or" later revision. In the State of California a
spark arrester is required under section
4442 of the California
Public resources code. Other states may have similar laws.
WARNING
DO NOT wear loose clothing, iewelry or anything that may
be caught in the starter" or other rotating parts.
, Tie up long hair and remove jewelry:
WARNING
NEVER aim spray gun at people, animals or plants,
DO NOT allow CHILDREN to operate pressure washer:
NEVER repair high pressure hose, Replace it,
NEVER repair leaking connections with sealant of any kind.
Replace o-ring or seal
Keep high pressure hose connected to pump and spray gun
while system is pressurized.
ALWAYS point gun in safe direction and squeeze spray gun
trigger, to release high pressure, every time you stop engine.
Engage trigger loci< when not in use.
WARNING
Always wear safety goggles when using this equipment or in
vicinity of where equipment is in use.
Before starting the pressure washer, be sure you are wearing
adequate safety goggles.
WARNING
WNEN ADJUSTING OR MAKING REPAIRSTOYOUR
PRESSURE WASHER
• Disconnect spark phJg wire from spark phJg and place wire
where it cannot contact spark piug.
WHEN TESTING FOR ENGINE SPARK
Use approved spark plug tester.
DO NOT check for spark with spark phJg removed.