Troy-Bilt 020210 Manual Del Usuario página 9

Section 3: Assembly
2.
Similariy, attach other end of high pressure hose to
high pressure oudet on pump (Figure 5). Puli down on
collar of quick connect_ siide onto pump and iet go of
collar. Puli on hose to be sure of tight connection.
Connect high
pressure hose here
3.
Before connecting garden hose to water iniet_ inspect
iniet screen (Figure 6).
Ciean screen if it contains debris, repiace if damaged.
DO NOT RUN PRESSURE WASHER IF SCREEN IS
DAMAGED.
Inspect iniet
screen, DO NOT
use if damaged,
dean if dirty.
4. Run water through garden hose for 30 seconds to
dean out any debris.Turn off water.
mMPORTANT: DO NOT siphon standing water for the
water supply. Use ONLY cold water (Hess than H00°F).
S. Connect garden hose (not to exceed S0 feet in length)
to water inlet.Tighten by hand (Figure 6).
. Damageto equipment resulting from failure to follow this
instruction will void warranty.
6. Turn ON water, point gun in a safe direction and
squeeze trigger to purge pump system of air and
WARNING
Always wear safety goggles when using this equipment or in
vicinity of where equipment is in use.
Before starting the pressure washer, be sure you are wearing
adequate safety goggles.
Checklist Before Startin Eg ine
Review the unit's assembiy to confirm you have performed
ali of the following:
i. Hake sure handie is in piace and secure.
2. Check that oii has been added to proper ievei in
engine crankcase.
3. Add proper fuei to fuei tank.
4. Check for properiy attached hose connections.
S. Check to make sure there are no kinks, cuts, or
damage to high pressure hose.
6. Provide a proper water suppiy (not to exceed H00°F)
at an adequate flow.
7. Be sure to read "Safety Rules" and "HowTo Use
Pressure VVasher" before using pressure washer.
O