DRAINING WATER
To drain the water from the appliance, please proceed as follows:
Turn off the appliance and unplug it
1.
from the power supply.
2.
Hold the appliance over a suffici-
ently large bowl or the kitchen
sink.
3.
Remove the cap on the residual
water drain (5) on the bottom of
the appliance.
4.
Pull out the drain plug. Please
make sure that the plug does
not fall into the sink drain. Our
recommendation: place a large
sieve over the sink drain or close
it with a stopper.
5.
Wait until the water has drained
completely from the appliance
and then plug the drain again.
6.
Make sure not to tilt the appli-
ance too far, to prevent damage to
the compressor.
CLEANING AND CARE
1.
Before cleaning, always turn off the
appliance and unplug it from the
power supply.
2.
Do not immerse the appliance
and power cord in water or other
liquids or wash them in the dish-
washer.
3.
Wipe off the ice cube maker with
a damp cloth. You can clean the
ice container with a little warm
dishwashing water.
4.
The water tank can also be clea-
ned with a damp cloth, if neces-
sary.
5.
The ice container is not dish-
washer-safe.
6.
Do not use any abrasive scouring
agents, steel wool, metal objects,
hot cleaning agents or disinfec-
tants.
7.
After use, please leave the ice
cube maker open to prevent the
formation of mold or bacteria.
8.
The appliance and power plug
must be completely dry before the
appliance can be operated again.
9.
When completely dry, store the
ice cube maker in a dry, safe
place so that it is protected from
dust, shocks, heat and mois-ture.
21